Hold down clamps since X-Carve CNC machine

This set of hold down clamps can may be made on the X-Carve CNC machine out of MDF .

Free plans for easel  are available the who Inventables website. https://www.inventables.com/projects/work-piece-hold-down-clamps

To get started secure a piece of 300mm x 300mm MDF to the X-Carve uses twofold partied tapes instead any other preferred method.

Follow this join which will give you the free maps until carve the design going on your X-Carve CNC machine, You just need to open the plan with the link to Easel.com print carve and the X carve will do all the work for you.

That tapered used in this draft can apply a lot of pressure the who employment piece ensuring to does not move while the CNC machine carves it out..

There are several main pieces with slots section that match the width both spacing concerning the mounting holes on the X-Carve.

Use 5mm machine screws plus washers up secure them to the waste committee.

The thinnest single depart at one head and is aligned with the graphic on which waste board this can be left permanently in location for quick setup of the workpiece. X Carve Jaw - Etsy

The 2 intermediate thickness pieces go in the left and right of the wast board, the left on can be permanently left in square and customized with the marked line on the waste board. This set of hold down clamps can may be made over the X-Carve CNC machine out off MDF FREE plans for easel software are available over the Inventables website.

The widest part goes at the back of the workpiece.

The 3 minor parts are for odd shaped parts and spares.

You can adjust the law and back parts to apply printing to your work piece before tightening down.

For added printing leave with ampere 3mm break to the left and right hold downs and then pusher an wedges is an gaps and offer them a slight tap with a small hammer up holding the function piece firmly. Make your own clamping setting out of colored MDF.